Setting The Ibmc Ip Address - Huawei FusionServer Pro CH121 V5 User Manual

FusionServer Pro CH121 V5 Compute Node
User Guide
----End

4.3.5 Setting the iBMC IP Address

Scenarios
This section describes how to set the iBMC IP address on the MM910 WebUI.
You can set the iBMC IP address on:
l
l
l
l
l
Procedure (on the MM910 WebUI)
Step 1 Log in to the MM910 WebUI.
For details, see
Step 2 Set the iBMC IP address
To avoid conflicts with the network segment of the chassis management plane, the iBMC IP
address of the compute node cannot be configured in the 172.31.xx.xx network segment. If
you need to configure the iBMC IP address, change the IP addresses of the HMM and
compute node in the network segment of the chassis management plane. For details, see
section "Querying and Setting a Network Segment for the Chassis Management Plane
(subnet)" in
1.
2.
Issue 06 (2019-08-10)
For details, see FusionServer Pro E9000 Server V100R001 HMM Alarm
Handling.
– If no, no further action is required.
BIOS
MM910 WebUI
For details, see MM910 Management Module V100R001 User
MM910 CLI
For details, see MM910 Management Module V100R001 Command
iBMC WebUI
For details, see FusionServer Pro E9000 Server iBMC User
iBMC CLI
Run the following command: ipmcset -d ipaddr
For details, see FusionServer Pro E9000 Server iBMC User
12.3 Logging In to the MM910
MM910 Management Module V100R001 Command
On the HMM Web page, choose Chassis Settings.
The Chassis Settings page is displayed.
In the navigation tree, choose Network Settings > Node.
Copyright © Huawei Technologies Co., Ltd.
4 Installation and Configuration
Guide.
Guide.
Guide.
WebUI.
Reference.
Reference.
82