Huawei FusionServer Pro CH121 V5 User Manual page 148

FusionServer Pro CH121 V5 Compute Node
User Guide
Step 2 Connect the local PC to the MM910.
l
Issue 06 (2019-08-10)
Connect the network port of the local PC to the MGMT port of the active or standby
MM910.
If the MGMT port on the active MM910 is already connected with a network cable, do
not remove the network cable from the MGMT port. Otherwise, an active/standby
switchover of the MM910s will be triggered, which may cause network interruption.
Figure 12-2 Network connections
NOTE
The MM910 management port is provided by either of the following modes:
– An Ethernet port on the switch module in slot 2X or 3X
However, if a CX910/CX911/CX912/CX913 is in slot 2X or 3X, only a GE port can be used;
if a CX920 is in slot 2X or 3X, only a 10GE port can be used. Do not use the ports on the
CX910/CX911/CX912/CX913 as the management port of the management module.
– MGMT port on the MM910 panel
For the MM910 (U54)2.25 or earlier, the management port is provided by the switch module by
default. For the MM910 (U54)2.26 or later, the management port is provided by the MM910 by
default. For details about how to query the MM910 version, see
V100R001 User Guide.
You can run the outportmode command to change the mode in which the MM910 management
port is provided. If the switch module in slot 2X or 3X is used to provide the management port, do
not connect the MM910 MGMT port and the switch module ports to the same network.
Otherwise, a network storm will occur and the network will be interrupted. For details, see
MM910 Management Module V100R001 Command
Copyright © Huawei Technologies Co., Ltd.
12 Common Operations
MM910 Management Module
Reference.
140