Installing A Processor - Huawei FusionServer Pro CH121 V5 User Manual

FusionServer Pro CH121 V5 Compute Node
User Guide
Step 13 Upgrade the firmware and driver to the latest versions.
You can obtain the latest firmware and driver versions from
website.
l
l
----End

5.2.7 Installing a Processor

l Do not wear ESD gloves during processor replacement. The gloves may catch on pins on
l The same model of processors must be used in a server.
l Before installing a processor, clean the surface of the processor, the heat sink, and the
l Intel heat sinks or Huawei-developed heat sinks are used, depending on the processor
Procedure
Step 1 Power off the compute node.
For details, see
Step 2 Remove the compute node.
For details, see
Step 3 Place the compute node on the ESD workstation.
Step 4 Remove the cover.
For details, see
Step 5 Remove the air duct.
For details, see
Issue 06 (2019-08-10)
NOTE
The method used to query the firmware version varies depending on the operating system:
– For Linux and VMware ESXi 5.1 or earlier, run the ethtool -i eth <value> command to
check the firmware version: In the command, <value> indicates the port number.
ethtool -i eth <value>
For VMware ESXi later than 5.1, run the esxcli network nic get -n vmnic <value>
–
command to check the firmware version: In the command, <value> indicates the port
number.
esxcli network nic get -n vmnic <value>
For details about how to upgrade the firmware, see section "Upgrading Mezzanine
Cards" in E9000 Server V100R001 Upgrade
For details about how to upgrade the driver, see section "Installing Drivers and
Firmware" in Huawei Server OS Installation
the processor socket and damage it.
processor carrier. If there is residual thermal compound, use a tissue to clean it.
cooling solution.
3.1 Power-Off
3.3 Removing a CH121
3.5 Removing the
3.7 Removing the Air
Copyright © Huawei Technologies Co., Ltd.
Guide.
Guide.
Procedure.
V5.
Cover.
Ducts.
5 Optional Part Installation
Huawei technical support
103