T04-06 Setting An Ip Address; T04-07 Verifying The Location Indicator Function - Huawei Tecal RH2485 V2 Operation Manual

Acceptance Manual
Tecal RH2485 V2 Server
Test Description

T04-06 Setting an IP Address

Objective
Test Networking
Diagram
Preset Conditions
Test Procedures
Expected Result
Test Description

T04-07 Verifying the Location Indicator Function

Objective
Test Networking
Diagram
Preset Conditions
Test Procedures
successfully.
To verify that you can set an IP address on the iMana Web.
None
1. AC power is supplied to the server.
2. The IP address of the iMana management network port is obtained.
3. Internet Explorer 8.0 or Firefox 9.0 is installed on the terminal.
4. JRE1.6u25 or later is installed on the terminal.
5. The terminal is connected to the iMana network port of the server over the
network.
1. Log in to the iMana Web.
2. Choose Configuration and click Network.
3. Select Manually Set an IP Address under IPv4. Enter an IP address, subnet
mask, and gateway address in the text boxes, and click OK. Ensure that the
new IP address is on the same network segment as the IP address of the
terminal.
4. Use the new IP address to log in to the iMana Web.
1. The IP address is properly configured.
2. The new IP address takes effect and can be used to log in.
After the new IP address is configured or obtained, use the IP address to log in again.
To verify the location indicator function on the iMana Web.
None
1. AC power is supplied to the server.
2. The IP address of the iMana management network port is obtained.
3. Internet Explorer 8.0 or Firefox 9.0 is installed on the terminal.
4. JRE1.6u25 or later is installed on the terminal.
5. The terminal is connected to the iMana network port of the server over the
network.
1. Log in to the iMana Web.
2. Choose Diagnose and Location and click Device Location.
11
Part II Operation Guide