Table of Contents
Advertisement
Question 15. What is the procedure to connect to KNX system?
The Wanderfull system supports an integrated connection or a KNX system connection only
or a Z-WAVE system connection only. As a result, the connection can be activated in two
ways:
a.
A direct connection in which the KNX IP address is required. This type of connection
can be required when some of home internet routers/switches block the multicast messages
inside LAN, and the best solution is direct connection.
b.
Connection by means of a multicast. The multicast connection type is the connection
when the KNX router listen/sends events to specific reserved IP address, additionally to
direct connections (if they exist).
For detailed explanation on how to connect the device with the application, please see the
KNX
section
in
http://www.touchwand.com/customer-support/
Question 16. How do I connect more than 1 switch to activate the same light?
There are few option for this case:
a. When there are 2 switches that are operating the same light you need to install the
InWand in the switch that is connected directly to the light.
Follow the connection scheme below.
b. When there are 3 switches that are operating the same light need to install the InWand
in the switch that is connected directly to the light. Follow the connection scheme below.
this
manual
or
Wanderfull Technical Manual
88
contact
us
on
our
website
Advertisement
Table of Contents
