Table of Contents
Advertisement
Wanderfull HUB Repair Process
1. This process repairs the database and installs the previous version (the earliest is version
187), which is already backed up locally in the Wanderfull Hub (only if version 188 was
already updated prior to this action).
2. Insert the PIN through the hole and press on the hidden reset push button located inside
the Wanderfull Hub for approx. 5 seconds.
3. The unit will beep once after 5 seconds.
4. Remove the pin from the hole.
5. The LED will flash twice in green lights and then the green lights will be on for approx. 10
seconds.
6. After approx. 10 seconds the unit will beep long once and the green LED lights will go
off.
7. The Wanderfull Hub will initiate the restart process that will take approx. 2 minutes.
8. Wanderfull Hub version will be 187.
9. Now you can update the firmware version again to the latest version – 188 or higher.
10. For visual review of the factory repair process press
Wanderfull Technical Manual
80
here
or scan the QR Code.
Advertisement
Table of Contents
