Table of Contents
Advertisement
In Advance Set adjust the Video Encoding - H.264 and Extended Code - baseline.
Note: If a camera is already included into the controller but the settings are not
configured properly use the following steps: Remove the camera from the
controller. Configure the camera settings. Install the camera to the controller.
Once these configurations are done, Tiandy, HiLook, Provision or Hikvision cameras can be
added in the TouchWand application. Camera units are located in the Units tab. To add a
new IP camera in the controller, first click on the Add Unit button located in the Units tab.
In the new screen that will appear, select the type of the unit, in this case IP camera (ONVIF)
and then click on the Pair button.
Wanderfull Technical Manual
31
Advertisement
Table of Contents
