Risco Protocol; Connecting Touchwand Products To Risco Alarm - TouchWand Wanderfull User Manual

RISCO protocol

Connecting TouchWand products to RISCO Alarm

RISCO Alarm system connection to Wanderfull controller is visible in the Alarm submenu
under Settings tab and available for editing only for users with technician privileges!
Note: To enable working with Risco alarm application in parallel with
Wanderfull application Risco alarm should have multi-socket card.
The user with Administrator permissions will be able to arm, disarm and reconnect the
unit as seen in the picture below.
After the you've finished installing the alarm system, follow these steps to allow
connection to the TouchWand system:
1. Make sure Risco has Multi-Socket
2. In the user keyboard, press the menu button
3. Enter your password
4. go to Activities → config SW → CS connect → via IP
5. Press 'V'
To install Risco click on the Settings tab located at the bottom right of the application. RISCO
settings can be added and edited in the Settings tab under the Alarm sub menu.
Click on the Add Risco button. At this moment RISCO alarm system is not connected and its
status is Disabled not mounted. After clicking this button, check Enable connection box. You
Wanderfull Technical Manual
67