Table of Contents
Advertisement
General Settings - Z-WAVE System Setup
About the Z-Wave system
1. Z-WAVE is the most popular smart home system standard in the world! Over 400
companies in the world are using this standard. It is now the only standard in the
wireless field.
2. The system operates at an independent wireless frequency according to the Ministry
of Communication standard - 916MHZ (does not operate in the WI-FI network
environment which is considered a busy network).
3. The standard Z-WAVE ensures customers two important issues - a system with a
variety of suppliers and the possibility to purchase equipment from other sources and
from the Internet.
4. The method of operating the system is in the form of MESH - meaning that each unit
operates autonomously without the need for a management system and activates the
other switches in the system.
5. There is no need for a central system to operate the house in a smart way. The system
enables independent operation of each unit independently of other factors.
6. A power failure does not affect the system and the units because each unit has
internal protection.
7. The management system enables control of the application, including management
of different calendars and languages.
The Z-Wave submenu is visible and available for editing only for users with
technician/installer privileges!
Associations
When opening the Z-Wave Settings, the user is able to create associations from the
Associations tab.
Associations are made directly between one device and another - it can control one
device or a small 'group' of other devices (typically 5 or 6 units).
The advantage of using Associations is that commands are sent directly from the
controlling device (source) to the controlled device(s) (targets), and not via the central
Z-Wave controller, or in this case - the Wanderfull hub. This can save time when
performing actions that involve a few units set up in close proximity, in an area far from
the controller.
Create an association
• Enter to Settings → Z-Wave
• Choose source unit, do not choose source unit that ends with "_root"!
Wanderfull Technical Manual
55
Advertisement
Table of Contents
