TouchWand Wanderfull User Manual page 86

a. Open the application, go to the shutter and slide the shutter up to 100% or just click on
the up button and wait until it shows 100%.
b. Push on the up-switch for the amount of time it takes the shutter to open to its full 100%.
Remember if the shutter is open in 50% and the full opening time is 25 seconds you need to
hold the switch up for at least 25 seconds even if the shutter got to its upper position after
12 seconds. Only when the shutter will make the whole path it will get into its calibrated
known state.
Question 9. How can I remember my password?
Most of the browsers support remember password option. While login the first time or after
delete history you can use the remember password option and the browser will save your
password.
For example, Google Chrome (menu Settings/Advanced/Passwords and forms) offers the
possibility to fill in and save passwords
In the application via mobile, if you are connected with one controller, it will remember the
last login and password entered.
Question 10. Who can help me to build the scenario?
Detailed description about building the scenarios can be found in the What's new
documents, installation and in the Scenario section in this manual.
You can always send us a message through our website and e-mail on the following link
http://www.TouchWand.com/contact/ or contact our offices.
Question 11. How can I use the timer on the scenario page?
The timer in the scenarios page is used for switches that are considered as lights, other
on/off switches that are part of "lights" dropbox action in the scenario, hot water boiler
activation or similar devices and other devices. Any user can switch on/off a switch many
times along the 24 hours, or even build up a sequence of actions with different switches by
adding another action one after the other using the same scenario based on the same
condition. The timer can be set for up to 24 hours (1,440 min) from condition triggered.
Example:
Go to the Scenarios tab in the application and click on "Add Dynamic Scenario". Enter the
name of the scenario, condition and action. When entering the condition which in this case
is time, define the time you want the scenario to start. For example, I want to switch on a
light at a certain time for 2 hours (120 min). In the Action section define the actions to be
performed.
Action #1 Hallway light "on" (no timer is needed because you want the light to switch "on"
when the condition is triggered. Then add another action using "and" Action #2 Hallway light
Wanderfull Technical Manual
86