Table of Contents
Advertisement
Once you select the desired type and click Pair, the controller will start scanning for all
the potential units under the type you chose. Adding a unit will be performed parallel to
the scanning of the controller while clicking on the configuration button (usually 3 times
depending on the type of unit and its directory settings) while the camera is required to
press and hold the RESET UNIT button until the camera sound is heard. When the process
is completed, the name of the unit and the appropriate icon and management area of
that unit must be defined. Further explanation on the pairing process can be seen in this
manual (for cameras, and coolmasters), and in each unit's manual for TouchWand
products.
Once the unit is added, there is a possibility to see the unit's activity through in the Status
section. This can be very helpful when the device is not working properly.
You can combine units from the Z-Wave, KNX, or IP work environments.
On the lefthand side of the screen you can see the units list.
You can sort the units using the following conditions:
1. Alphanumerical
2. Unit ID (the order in which the units were added to the system)
Wanderfull Technical Manual
19
Advertisement
Table of Contents
