Table of Contents
Advertisement
▪ Unlike other units, there is no need for pairing this unit. Just click on the Add unit
button and select what kind of unit will be added in the first field, in this case PIMA
sensor (as seen in the picture below). Enter the rest of the data that is needed - type,
sensor name and zone and click on the Pair button.
Once this is done, the unit is added to the controller.
The PIMA alarm has flood, motion, magnet and smoke sensors. Every sensor reports via
the alarm application to Wanderfull about it's status. The system identifies the statuses
activates them accordingly (when the alarm system is triggered/neutralized).
Note: Please disarm and arm the system to make sure that the system is
responsive and working correctly with the Wanderfull controller.
Click on the Settings tab located at the bottom right of the application. PIMA Alarm
settings can be added and edited in the Settings tab.
First, the user should check the box Enable connection.
Wanderfull Technical Manual
65
Advertisement
Table of Contents
