Table of Contents
Advertisement
A possible cause of the phenomenon
1. Some units are connected to the controller but are out of range
2. After the initial definition, disturbing units were added, such as a cabinet, mirror
and any other possible factor
3. A unit appears in the list of units as MALFUNCTION, meaning an invalid unit
4. A concrete/reinforced wall that affects the local media
Recommendations for solving the problem
1. Add a relay unit to increase the range and check that there are no units that
appear as MALFUNCTION, that is, a valid unit, in the UNITS menu
2. Perform a procedure called Update Z-Wave network through the Z-WAVE menu
in the Settings tab
3. The unit must be removed from the list - either by resetting or re-adding or
deleting, and the unit can be replaced by selecting REPLACE after pressing the
trash button
4. Position the antenna with respect to the frame plastic of the switch. The antenna
should exit the micro module
Wanderfull Technical Manual
84
Advertisement
Table of Contents
