Table of Contents
Advertisement
Wanderfull Hub Factory Reset / Version Repair
The following process describes the steps to perform factory reset or to perform version
repair process of the Wanderfull Hub.
Both processes are enabled only from firmware version 188 and up.
Therefore, before performing factory reset / repair please verify that the Wanderfull Hub
version is 188 or higher.
Carefully follow the following steps:
Preparations:
Make sure you have a Pin 0.75
mm diameter X 30 mm
(minimum).
A suitable Allen key with these
specifications will do the job or
y
can use any type of a small
ou
paper clip with the diameters as
defined.
Connect the Wanderfull hub to power
Insert the Pin through the small
hole, on the top right side of the
Wanderfull HUB.
The pin should be inserted in
vertical position to the ground
of the surface of the Wanderfull
HUB.
When inserting the pin, you
should feel the push button
before making the long press.
Proper insertion
Wanderfull Technical Manual
79
Advertisement
Table of Contents
