Advanced Z-Wave Settings - TouchWand Wanderfull User Manual

• When finished, click on the save bottom

Advanced Z-Wave settings

In the Advanced tab, you can update/heal and reset the Z-Wave network. There is also a
possibility to remove a unit, by entering the node ID in the Remove by note ID field.
NETWORK UPDATE – this stage takes place after all the end units have been defined in
the structure and after the functionality of each one has been tested. The purpose of this
procedure is to optimize the communication between the management unit and the end
units. The duration of the procedure varies from site to site and on average takes about
15 minutes. While the procedure is being performed, do not touch/change physically
and/or virtually the endpoints for the success and efficiency of the process.
NETWORK RESET – this is a sweeping reset of all Z-WAVE units on the network,
including the disconnection of existing units from the controller only! Once we want to
reuse these units, a local RESET must be performed for each unit at the endpoint. This
means that even if NETWORK RESET is done and we want to go back to the previous
step, you can load an existing backup in the system and the endpoint units can
communicate immediately with the management unit.
JSON Editor
In the Z-Wave sub menu you can see the WallWand JSON Editor button.
Wanderfull Technical Manual
57