Implementation Of Primary-Secondary Controllers - TouchWand Wanderfull User Manual

Implementation of primary-secondary controllers

Configuring primary and secondary controllers is available only for users with technician
privileges!
Primary-secondary controllers are implemented with the 187-th firmware version.
For large size spaces that include several floors and many units, it is advisable to include
more than one controller in the network.
Controllers can be connected through wired IP and could control the house/building
easily. Therefore, you need to set up one primary controller that can include several
secondary controllers and would include all secondary units. Once this is done, you can
build up scenarios between units that are paired to different controllers.
When logging in to the application, the user is able to choose between installed controllers
at the premises. This is visible at the login page in the filter located below the password.
Note: All primary and secondary controllers must be on the same local
network! This is important for the primary secondary configuration.
After the desired IP address of the controller is selected, click on the Submit button and
enter the application.
With this firmware version the you have the possibility to name a controller. This is
possible through the Settings tab, in the General sub menu. Under General configuration,
you can enter the name of the controller in the new field Controller name.
Wanderfull Technical Manual
75