2.5 CO Line Programming
[423] ISDN Layer 1 Active Mode
Description
Assigns the active mode of Layer 1 on ISDN port basis.
Selection
• Port number:
KX-TD816 – 01 through 04,
KX-TD1232 – 01 through 12,
( =all ports)
• Permanent / Call
Default
All ports – Permanent
Programming
1.
Enter 423.
Display: L1 Active Mode
2.
Press NEXT.
Display: Port No?
3.
Enter a port number.
To enter a first port, you can also press NEXT.
Display example: #03:Permanent
4.
Keep pressing SELECT until the desired selection is displayed.
5.
Press STORE.
6.
To programme another port, press NEXT or PREV, or SELECT and the desired port
number.
7.
Repeat steps 4 through 6.
8.
Press END.
Conditions
• In case of KX-TD1232, port numbers 01 through 06 are for the Master System and 07
through 12 are for the Slave, if available.
• To assign all ports to one selection, press the
the contents programmed for a first port.
• After this assignment, you should reset the system so that this assignment is effective.
174
key at step 3. In this case, the display shows
General Programming