Panasonic KX-TD1232NE Programming Manual page 60

2.1 Manager Programming
Conditions
• A maximum of ten digits, consisting of 0 through 9, can be assigned as the rate. The number
of decimal places depends on the assignment in programme [015] Charge Rate Fractional
Point Assignment.
• When the ISDN card or unit is installed to the system, the rate cannot be assigned per CO
line. The rate which is assigned to the lowest CO line number is used for the other lines.
For example, when the KX-TD280 is installed to the KX-TD1232, the rate assigned to
CO09 is used for CO 10 through 12.
• If a different rate is assigned to each CO line, the extension charge fee, account code charge
fee and total extension charge fee meters will not be displayed correctly. In this case, the
meter is calculated by the rate assigned to CO1.
• When the ISDN S0 line unit or card is installed, you have to restart the system after
programming. Otherwise, the correct charge may not be displayed. Refer to 2.6.1 System
Restart.
Feature References
Charge Fee Reference
60 General Programming