Table of Contents
Advertisement
7.3.1 Installation of AirLINE Quick
To install AirLINE Quick, a cut-out must be provided on the base
of the control cabinet. The cut-out can be created, e.g., through
laser-cutting or punching.
Assignment of the pneumatic connections and the
dimensions of the flange images can be found online at:
www.burkert.com
noTe
▶ The cut-out on the control cabinet must be burr-free for the
seal not to become damaged between AirLINE Quick and
the control cabinet.
→ Insert the seal between AirLINE Quick and the control cabinet
free from damage into the groove of the AirLINE Quick metal
plate.
→ Place the valve block in the control cabinet on the prepared
cut-out.
→ Attach the stability plate from the outside and fix with M5x10
screws.
Type 8647
Installation
7.4
Disassembling from the standard rail
in the control cabinet
Danger
risk of injury when the device is connected electrically and
pneumatically.
If the device has been connected electrically and pneumati-
cally, carry out the following before disassembling:
▶ Secure the actuators against moving.
▶ Switch off pressure. Vent or drain lines.
▶ Switch off the power supply. Secure against reactivation.
CauTIon
risk of injury as a result of a heavy device falling.
The valve block is not connected securely to the standard rail
after loosening the fastening screws.
▶ Make sure the valve block cannot fall down during the entire
deinstallation process.
→ Disassemble the server module installed to the right of the
valve block and any SIMATIC ET 200SP BaseUnits according
to the manufacturer's instructions.
→ Turn the fastening screws of the valve block (see "Fig. 7")
carefully all the way counter-clockwise. Hold the valve
block! The valve block is not connected securely to the
standard rail after loosening the fastening screws.
english
19
Advertisement
Table of Contents
