Config Menu (Config) - ITech IT8500plus Series User Manual

UPDATE(default)
OLD
SOURCE
MANUAL(Def)
EXTERNAL
TRIGGER
BUS
HOLD
MEMORY
MEMORY
GROUP= 0
DISP-TIMER
DISPLAY
ON
OFF(default)
RS-232
4800_8N 1
9600_8N 1
RS-232
19200_8N 1
38400_8N 1
SCPI
PROTOCOL
FRAME
ADDRESS= 0
ADDRESS
RUN
NORMAL
BATTERY
RUNMODE
PROG_TEST
OCP_TEST
OPP_TEST
DEFAULT
DEFAULT
NO
YES

3.6 Config Menu (Config)

Press [ Shift ]+ [ 9 ] (Config) to enter the menus.
Max-P
PROTECT
MAX POWER=150.00W
The value modified with knob during operation will be
saved after load is off.For example; the DC load is set
to 1A by press [CC] and turned on the input.Then
increase the setting value to 2A with knob.When
customer turn off load and trun on again, the setting
value changes to 2A.
As explained above, after the DC load is turned on
again,the setting value is 1A instead of 2A changed
with knob.
Triggered from the [ Shift ] + [
Triggered from a TTL high signal at the trigger
connector on rear panel
Triggered from a serial bus command 5AH
Receving a command 9DH
0:indicates1-10 group;1:indicates 11-20group, by parity
of reasoning
Enable timer function
Disable timer function
Baudrate 4800, data bit 8, none parity, stop bit 1
Baudrate 9600, data bit 8, none parity, stop bit 1
Baudrate 19200, data bit 8, none parity, stop bit 1
Baudrate 38400, data bit 8, none parity, stop bit 1
Select SCPI protocol
Select FRAME protocol
Set the instrument's address(0~31)
Runing mode at power on
Normal mode
Default in battery test mode at power on
Default in autotest mode at power on
Default in OCP test mode at power on
Default in OPP test mode at power on
Do not return instrument to factory default settings.
Retrun instrument to factory default settings
Set hardware OPP value
Copyright © Itech Electronics Co., Ltd.
Functions and Characteristics
Set trigger mode
] key
Recall the prestored datas
Timer function
Set hardware power protection
17