ITech IT8500plus Series User Manual page 27

A-LIMIT
A-LIMIT
ON
A-LIM POIN=30.000A
A-LIM DELAY=3S
OFF
P- LIMIT
P-LIM POIN=150.00W
P-LIM DELAY=3S
TIMER
LOAD-TIMER
ON
LOAD-TIMER=10.0S
OFF
V-RANGE
V-RANGE
ON
OFF
FILTER
MEASURE
FILTER COUNT = 2^14
TIME-V1
TIME-VOLT1=0.000V
TIME-V2
TIME-VOLT2=120.00V
CR-LED
CR-LED
ON
OFF
REM- SENSE
SENSE
ON
OFF
VON
LIVING
VON
VON POINT = 0.10V
LATCH
VON POINT = 0.10V
RESET
RESET NO
YES
Enable software over current protection function
Set the software OCP level
Set the OCP delay time
Disable the software OCP funtion
Set the software OPP level.
Set the OPP delay time.
Enable load-on timer
Set the load on time(0.1S~9999.9S)
Disable load on timer
Enable voltage auto range function
Disable voltage auto range function
Filter count set, range 2~16
Set the start time, to measure the voltage rise/fall time.
Set the end time, to measure the voltage rise/fall time
Open the function(in CR mode,press [ Shift ]+ [ CV ] to
set Vd value)
Disenable the function
Enable remote sense function
Disable remote sense function
VON point living state
Set the VON value
VON point latch state, ON /OFF
Set the VON value
Do not reset
Reset
Copyright © Itech Electronics Co., Ltd.
Functions and Characteristics
Set software current protecting state
Set software power protecting state.
Set load on timer
Voltage auto-rangefuntion
Set the filter parameter
Imitate LED (in CR mode)
Remote sense function
Set the load's VON point
Reset the config menu
18