Clock Adjustment - Kenwood HM-636 Instruction Manual

Clock adjustment

As the clock is not only used to show the time of the day but also used in timer operations, be sure to set
the clock in advance.
1
Activate the Clock adjustment mode.
1
Select " TIME ADJUST ?"
\
\
(Press the set/demo key while the "?" mark is
blinking.)
2
Adjust the hour.
1
Select the figure of hour.
To decrease
hour
2
Set it.
3
Adjust the minute.
1
Select the figure of minute.
To decrease
minute
2
Set it.
\
\
÷ The time display starts to blink.
Example: Adjustment to 8:07
To increase
hour
÷ In other areas than Europe the clock shows the time of
÷ Press the set/demo key. The hour is entered and the
Example: Adjustment to 8:07
To increase
minute
÷ If you make a mistake, restart from the beginning.
÷ When the time of day has been set by pressing the
÷ After a power failure or the power cord has been un-
÷ When the 7 key is pressed while the power is in the
the day in the 12-hour system.
minute display starts to blink.
set/demo key, the display shows "COMPLETE".
plugged, the time set will be erased. You have to set
the time again when unit is switched on.
standby mode, the time of the day will be displayed for
5 seconds.
Timer operation
37
EN