Clock Adjustment - Kenwood HM-DV5 Instruction Manual

Clock adjustment

This unit incorporates a clock function. Be sure to adjust the correct time before using the timer function.
If there is a power failure or the power cord is unplugged then plugged in again while the power set to off (STANDBY
mode) after a timer is activated, the STANDBY/TIMER indicator blinks in amber. In this case, adjust the clock again.
Switching the power ON
1
Activate the clock adjustment mode.
1
Press the MODE key.
2
Turn the VOLUME/MULTI CONTROL knob
to select "TIME ADJUST", then press the
SET/ DEMO key.
3
Turn the VOLUME/MULTI CONTROL knob
to select "12 HOUR" or "24 HOUR", then
press the SET/DEMO key.
2
Enter the figure of hour.
1
Adjust the figure of hour by turning the
VOLUME/MULTI CONTROL knob.
VOLUME/
MULTI CONTROL
To decrease
hour
2
Set it.
SET/DEMO
3
Enter the figure of minute.
1
Adjust the figure of minute by turning the
VOLUME/MULTI CONTROL knob.
VOLUME/
MULTI CONTROL
To decrease
minute
2
Set it.
SET/DEMO
MODE
To increase
hour
To increase
minute
T I M E
> 1 2
Blinks Select the time display mode.
÷ The time of the day is represented in 12-hour or 24-
hour method.
Example for adjusting at 1:30PM
PM
÷ The time display starts to blink.
÷ Press the SET/DEMO key. The hour is entered and the
minute display starts to blink.
Example for adjusting at 1:30PM
PM
÷ If you pressed the SET/DEMO key by mistake, press
the MODE key and restart from the beginning.
÷ To adjust correct time, press the SET/DEMO key at
the same moment as a time announcement.
÷ When the STOP7/TUNING MODE key is pressed
while the power is in the standby mode, the time of the
day will be displayed for 5 seconds.
Controls and indicators
A D J U S T
H O U R
P.S
0
kH
Blinks
P.S
0
kH
Blinks
15