Table of Contents
Advertisement
Clock adjustment
As the clock is not only used to show the time of the day but also used in timer operations, be sure to set
the clock in advance.
1
Activate the Clock adjustment mode.
1
Select " TIM E ADJUST ?"
\
\
(Press the set/ demo key w hile the "?" mark is
blinking.)
2
Adjust the hour.
1
Select the figure of hour.
To decrease
hour
2
Set it.
3
Adjust the minute.
1
Select the figure of minute.
To decrease
minute
2
Set it.
\
\
÷ The time display starts to blink.
Example: Adjustment to 8:07
To increase
hour
÷ In other areas than the U.K. and Europe the clock
÷ Press the set/ demo key. The hour is entered and the
Example: Adjustment to 8:07
To increase
minute
÷ If you make a mistake, restart from the beginning.
÷ When the time of day has been set by pressing the
÷ After a pow er failure or the pow er cord has been un-
÷ When the 7 key is pressed w hile the pow er is in the
show s the time of the day in the 12-hour system.
minute display starts to blink.
set/ demo key, the display show s " COM PLETE ".
plugged, the time set w ill be erased. You have to set
the time again w hen unit is sw itched on.
standby mode, the time of the day w ill be displayed for
5 seconds.
Timer operation
37
EN
Advertisement
Table of Contents
