Xilinx SP701 User Manual page 30

The detailed FPGA connections for the feature described in this section are documented in the
SP701 board XDC file, referenced in
MIPI-CSI
The SP701 board supports MIPI-CSI. The Digilent PCAM module has been tested with this
board. MIPI-CSI interface is connected to AMP/TE Connectivity 1-1734248-5 15-pin connector
J8. MIPI-CSI interface is shown in the following figure.
Spartan-7 FPGA
See the Digilent website for information about
UG1319 (v1.0) July 12, 2019
SP701 Board User Guide
Appendix B: Xilinx Design
Figure 14: MIPI-CSI Interface
CSI_LP0_P 100E
CSI_D0_P
CSI_D0_N
CSI_LP0_N
100E
CSI_LP1_P
100E
CSI_D1_P
CSI_D1_N
CSI_LP1_N
100E
(Slave)
CSI_LP_CLK_P
100E
CSI_CLK_P
CSI_CLK_N
CSI_LP_CLK_N
100E
Chapter 3: Board Component Descriptions
Constraints.
CSI_D0_P
CSI_D0_N
CSI_D1_P
CSI_D1_N
CSI_CLK_P
CSI_CLK_N
I2C2_SCL
I2C2_SDA
Pcam 5.
Send Feedback
Camera
Interface
Connector
(Master)
X22796-050319
www.xilinx.com
30