Xilinx SP701 User Manual page 28

Table 10: MSP430 TCA6416A U24 I/O Expander Connections (cont'd)
Port #
P11
P12
P13
P14
P15
P16
P17
The TI TCA9548 and TCA6416 data sheets are on the
FPGA connections for the feature described in this section are documented in the SP701 board
XDC file, referenced in
HDMI Video Output
[Figure 2, callout 12]
The SP701 board provides a HDMI video output using the Analog Devices ADV7511KSTZ-P
HDMI transmitter (U18). The HDMI output is provided on a Molex 47151-1001 HDMI type-A
connector (J13). The ADV7511 is wired to support 1080P 60 Hz, YCbCr 4:2:2 encoding using
24-bit input data mapping.
The SP701 board supports the following HDMI device interfaces:
• 24 data lines
• Independent VSYNC, HSYNC
• Single-ended input CLK
• Interrupt Out Pin to FPGA
• I2C
• SPDIF
The HDMI output interface is shown in the following figure.
UG1319 (v1.0) July 12, 2019
SP701 Board User Guide
TCA6416A U24 I/O Expander Addr. 0b0100000, 0x40
Schematic Net Name
1VCURSNS_ALERT
NOT USED
M0_0
M1_0
M2_0
FMC_PRSNT_M2C_LT
PGOOD_VADJ
Appendix B: Xilinx Design Constraints
Chapter 3: Board Component Descriptions
DIR Connected Device
IN U33 INA226 POWER MONITOR ON VCCINT_1V
IN N/A
IN U1 FPGA CONFIG. BANK 0 MODE M0
IN U1 FPGA CONFIG. BANK 0 MODE M1
IN U1 FPGA CONFIG. BANK 0 MODE M2
IN J21 FMC LPC
IN U40 MP8756G VADJ regulator
Texas Instruments
Send Feedback
website. The detailed
www.xilinx.com
28