Table of Contents
Advertisement
User marker coordinates
In the
DATA (X Y)
column, the coordinates for
S START POINT and E END POINT of the
currently set user markers are displayed. with-
out such settings, the
Move the cursor to the X/Y data. Using the ENT
switch, new user markers can be drawn or al-
ready registered user markers can be modified.
The setting can be made in 1-pixel increments.
The top left of the effective screen serves as the
reference point (0001, 0001) of the coordinates.
From this point, the coordinates can be adjusted
in the pixel range of 1920 x 1080.
Default setting is (unregistered).
Resetting the data
With the
DATA (X Y)
magenta, hold down the
right-hand button on the mouse) longer than 3
seconds, and the preset data may be deleted ( ).
Coordinate reference point
This 1920 x 1080, Full-HD panel has the pixel
reference point (0001, 0001) at the top left of the
screen. The pixel at the bottom right on screen is
preset as the coordinates (1920, 1080).
X axis
Y axis
marker appears.
settings blinking in
switch (or the
- -
33
Marker lines and coordinate values
There are 2 line widths for the user markers.
However, the coordinate for the start point and
that for the end point are different by 1 pixel.
Pixel position in the coordinate for the "start point"
Line width: 2 pixels
Pixel position in the coordinate for the "end point"
Accordingly, in drawing a horizontal line, the
Y-direction address has a coordinate value with
1 pixel added, as shown below.
Pixel position (X, Y) in the coordinate for the "start point"
Pixel position (X+a, Y+1) in the coordinate for the "end point"
When a vertical line is drawn, the X-axis address
has a coordinate value with 1 pixel added, as
shown below.
Pixel position (X, Y) in the coordinate for the
"start point"
Pixel position (X+a, Y+1) in the coordinate for the
"end point"
Advertisement
Table of Contents
