Ikegami HLM-1705WR Operation Manual page 37

MODE5 (1357-2468)
MODE6 (1234-5678)
MODE7 (1357-8642)
MODE8 (12-34) During the display mode 1-2ch
and 1-4ch settings.
MODE8 (1234-5678) During the display mode
1-8ch settings.
* The display of MODE 4 varies depending on
the number of channels for the section
Default setting is 1(1357-2468).
Setting the channel display of audio level meter
Set the display channel of the audio level meter.
CH 1 2 CH1 to CH2 is displayed.
CH 1 4 CH1 to CH4 is displayed.
CH 1 8 CH1 to CH8 is displayed.
Default setting is CH 1-8.
Setting the brightness of audio level meter
Set the brightness of the audio level meter.
The level meter image transmissive mode or
nontransmissive mode can be set.
LOW
MID
HIGH
LOW (MIX) (Image transmissive mode)
MID (MIX) (Image transmissive mode)
HIGH (MIX) (Image transmissive mode)
Default setting is HIGH.
Setting the peak hold display of audio level
meter
Used to turn on and off the peak hold display.
Default setting is ON.
Setting the reference level
Set the reference level of the audio level meter.
-18dBFS
-20dBFS
Default setting is -20dBFS
Downmix setting
Set the 5.1 channel surround downmix.
Mix the 5.1 channel surround audio signal as-
signed to 6 channels of embedded audio into 2
channels and outputs from the speaker, the
headphone and the audio monitor output.
5.1ch surround super woofer(LFE) channel is not
mixed.
Setting the downmix formats
.
Select the mixing method to downmix 5.1ch audio
in "ISO/IEC" and "ARIB".
Default setting is ISO/IEC
Setting the Ls/Rs level
Set the coefficient of Ls/Rs to mix.
Set among -3dB/-6dB/-9dB/OFF.
(OFF
Default setting is
Setting the embedded audio channel assign-
ment of speaker (Lm)
Set the channel of embedded audio, which the
audio for 5.1ch surround Lm speaker (left side in
front) should be assigned from.
Default setting is CH1
Setting the embedded audio channel assign-
ment of speaker (Rm)
Set the channel of embedded audio, which the
audio for 5.1ch surround Rm speaker (right side
in front) should be assigned from.
Default setting is CH2
Setting the embedded audio channel assign-
ment of speaker (C)
Set the channel of embedded audio, which the
audio for 5.1ch surround C speaker (center)
should be assigned from.
Default setting is CH3
- - 27
)
3dB