Ikegami HLM-1705WR Operation Manual page 27

Setting the function assignment of F2 switch
The function assignment is selectable in the same
way as that shown above
switch on the front panel.
Default setting is VITC OFF.
Setting the function assignment of F3 switch
The function assignment is selectable in the same
way as that shown above
switch on the front panel.
Default setting is MIX TEST.
Setting the function assignment of F4 switch
The function assignment is selectable in the same
way as that shown above
switch on the front panel.
Default setting is VSC ON.
Setting the power on status ON/OFF
Even if another person changes the setting with-
out permission, you can use this function to revert
the setting anytime by turning on the power
again. This function is convenient if multiple
people are involved in the operation.
If this function is set to "ON", all settings and
data that had been changed before the power was
turned off are cleared, and the setting items and
data for the MENU and PRESET MENU that are
stored in the "STATUS MEMORY" of the section 6
are loaded.
When it is set to "OFF", the setting status is dis-
played the same as it was before the power is
turned OFF.
* If "LOARD FACTORY" of MENU13 is executed,
the contents stored in "STATUS MEMORY" will
be cleared.
Default setting is OFF.
by pressing the F2
by pressing the F3
by pressing the F4
- - 17
Executing the content that is stored in POWER
ON STATUS
The items to be stored in "POWER ON STATUS"
are executed here.
When the "STATUS MEMORY" is executed, the
setting items for the MENU and PRESET
MENU are stored (except some of the following
items). If the power is turned on with the
"POWER ON STATUS: ON" setting, all items
that are stored here will be loaded.
* The items that will not be stored in POWER ON
STATUS.
Internal gamma table value when the color
temperature adjustment is executed by APS-100
User marker setting value
The setting value of "H POSITION" and "V PO-
SITION" to be set in the MENU6 section.