Table of Contents
Advertisement
G/R ALL Displays the entire TALLY only when
it is solely set to ON.
If both R-TALLY and G-TALLY are set to ON,
they will be displayed on the left and right sides.
R-TALLY ON]
[G-TALLY ON]
[Both R and G-TALLY at ON]
Default setting is R/G.
Setting the same-size (dot-by-dot) display ON/OFF
Set to ON in order to reproduce the input signal in
its original pixels without enlargement or reduc-
tion.
This function can be assigned with the F1 to F4
switch on the front panel.
Default setting is OFF.
* Signals in 480i/575i format are not in square pix-
els. Therefore, the aspect ratio will be displayed
differently from the original image.
Setting the SDI channel switching lock ON/OFF
If you want to prevent the switching between A/B
channels of SDI signal from switching, set it to
"ON", and then fix the input channel.
It utilizes the MONITOR OUT terminal and is
effective in fixing the channel. It prevents acci-
dental channel switching.
Default setting is OFF.
* Before setting it to "ON", make sure the desired
SDI channel is selected.
Setting the format display ON/OFF before
switching signals
Used to set whether the channel and signal format
are displayed or not.
3SEC ON
Three seconds indication
CONT ON
Consecutive indication
OFF
Indication off
Default setting is 3SEC ON.
Executing the 2x/4x zoom function
A function used to enlarge the image 2x or
4x without screening.
You can check for any scratch on the CCD of
camera or for the delicate images.
The display area to be enlarged is displayed on the
left bottom of the screen.
The ENT switch is used to switch between 2x
and 4x.
- -
19
Advertisement
Table of Contents
