External Offset Settings: Ofc - Panasonic LP-GS Series Serial Communication Command Manual

⿎ Example of command settings
Condition: X-movement = 10, Y-movement = -5.5, Rotation movement = 120,
Number of overwritings = 2, Overwriting interval = 0.5,
Y-axis mirroring = 0, X-axis mirroring = 1, Proportional type = 1
• Setting
Transmission data
• Readout
Transmission data
Response data

3-10-2 External offset settings: OFC

Sets the I/O input method for "External Offset Function" to adjust the marking position for the entire marking data in the file.
⿎ Setting request data / response data for readout
Start
OFC
code
Sub command is "S" for the setting request data and "A" for the response data for readout.
⿎ Readout request data
Start
OFC
code
⿎ Data description
Name
Input method
Total data length
• Characters specified by SIN command and external offset function with I/O cannot be set together in one file.
• External offset function cannot be used with on-the-fly marking at regular intervals or on-the-fly marking with multiple
triggers.
• At LP-400/V compatible command mode, "Low 10-bit" and "SEO command" of the input method cannot be set and
readout.
⿎ Example of command settings
Condition: Input method = 2
• Setting
Transmission data
• Readout
Transmission data
Response data
114
[STX] ALC
[STX] ALC
[STX] ALC
Sub [Input method]
command 1-byte
R (Check sum)
Data length
Data contents
[byte]
"0": OFF
1 "1": Low 4-bit
"2": Low 8-bit
1 The data length is fixed.
[STX] OFC
[STX] OFC
[STX] OFC
S +010.000-005.500+120.00020.5011
R [CR]
A +010.000-005.500+120.00020.5011
(Check sum)
End code
It is the input method (I/O or communication
command) of the offset value.
S 2 [CR]
R [CR]
A 2 [CR]
ME-LP-GS-SR-COMP-3
[CR]
[CR]
End code
Remarks