Encoder Resolution: Enc - Panasonic LP-GS Series Serial Communication Command Manual

⿎ Example of command settings
Condition: Moving direction = 2, Line speed control = 1, Trigger mode = 0
• Setting
Transmission data
• Readout
Transmission data
Response data

3-11-2 Encoder resolution: ENC

Supported model: LP-RC series / LP-RF series / LP-RV series
Sets the encoder resolution value used for the on-the-fly marking. This setting is applied to all marking files.
⿎ Setting request data / response data for readout
Start
ENC
code
Sub command is "S" for the setting request data and "A" for the response data for readout.
⿎ Readout request data
Start
ENC
code
⿎ Data description
Name
Encoder resolution
Total data length
• The setting changed by this command is saved in the laser marker without overwriting to the file.
⿎ Example of command settings
Condition: Encoder resolution = 120.5
• Setting
Transmission data
• Readout
Transmission data
Response data
124
[STX]
[STX]
[STX]
Sub [Encoder resolution]
command 6-byte
R (Check sum)
Data length
[byte]
6 "005.00"–"600.00" [pulses/mm]
6 Fixed length.
[STX]
[STX]
[STX]
TRG S 210 [CR]
TRG R [CR]
TRG A 210 [CR]
(Check
sum)
End code
Data contents
ENC S 120.50 [CR]
ENC R [CR]
ENC A 120.50 [CR]
ME-LP-GS-SR-COMP-3
End code
Remarks
Only when line speed control is set to
"encoder input", set this value.