Panasonic LP-GS Series Serial Communication Command Manual page 117

Data length
Name
X-movement *
Y-movement *
Counter behavior
Total data length
* These items can be omitted when the both values are 0. It is not possible to omit one side of them.
⿎ Example of command settings
Condition: Step & repeat ON/OFF = 1,
Number of rows = 12, Number of columns = 4, Row step = 4, Column step = 8.5,
X-movement = 0, Y-movement =0, Counter behavior = 11
• Setting
Transmission data
• Readout
Transmission data
Response data
Data contents
[byte]
(8)
"-999.999"–"+999.999" [mm]
(8)
"00": Disable "Count individually"
When "Count individually" is enabled;
• With the count direction "Horizontal"
Count "Mark
Setting
OFF"
"10" ON
"12" ON
"20" OFF
2 "22" OFF
• With the count direction "Vertical"
Count "Mark
Setting
OFF"
"11" ON
"13" ON
"21" OFF
"23" OFF
Fixed length.
39 • When X-movement and Y-movement are not omitted: 39-byte
(23) • When X-movement and Y-movement are omitted: 23-byte
(1) • When step & repeat is OFF: 1-byte
• Response data for readout: 39-byte or 1-byte
[STX] SRC
[STX] SRC
[STX] SRC
ME-LP-GS-SR-COMP-3
• Moves the coordinate of the step
• When these settings are omitted,
• When the step & repeat is
• When the counter function
• When the counter function is not
Counter start
Top left
• When "Count individually" is
Top right
Top left
Top right
• When "Mark OFF" is set in the
Counter start
Top left
Top right
Top left
• "Counter starting position"
Top right
1012004004.000008.50011
S or
1012004004.000008.500+000.000+000.00011
R 1 [CR]
A 1012004004.000008.500+000.000+000.00011
Remarks
& repeat data (the all marking
data in the object group No.
1000).
"+000.000" is applied to each.
OFF, these values are always
"+000.000".
is used in the step & repeat,
specify how the counter value is
updated.
used in the step & repeat, set
"00".
disabled, the all counter values
are the same in one step &
repeat operation.
step & repeat fine-adjustment
to a specified data in the step
& repeat, the "count Mark OFF"
specifies if the counter value
of the unmarked data turns out
the vacant number (ON) or not
(OFF).
specifies the start position of the
counting in the step & repeat.
[CR]
[CR]
117