Panasonic LP-GS Series Serial Communication Command Manual page 75

Name Data length
(> Name in LP-400/V)
Horizontal and
vertical alignment
Character height
Character width
X-position
Y-position
Character spacing or
Character string
width
Linefeed spacing
Rotation angle
Font No.
Bold line width
Laser power
correction
Scan speed
correction
Pulse cycle
correction *
Total data length
* Only for LP-RF series and LP-RV series.
Data contents
[byte]
"0": Left and first baseline
1 "1": Center and first baseline
"2": Right and first baseline
Model
7
LP-GS051(-L)
LP-GS052
LP-RC350S
LP-RF200P
7
LP-RV200P
8
"-999.999"–"+999.999" [mm]
8
Model
7
LP-GS051(-L)
LP-GS052
LP-RC350S
7
LP-RF200P
LP-RV200P
7 "-180.00"–"+180.00" [°]
1 "1"–"9"
5 "0.000"–"6.000" [mm]
3 "000"–"999" [%]
3 "001"–"999" [%]
(3) "001"–"999" [%]
72 The data length is fixed.
or • LP-GS/LP-RC series: 72-byte
75 • LP-RF/LP-RV series: 75-byte
ME-LP-GS-SR-COMP-3
• Specifies which point in the
• With LP-400/V compatible
Setting range [mm]
"000.100"–"055.000"
To make the characters bold, set the
"000.060"–"030.000" ratio of the character height and width
not to be other than the range from
"000.100"–"085.000"
1/10 to 10.
"000.100"–"090.000"
Specifies the origin coordinate of
character strings.
Specifies a character spacing for fixed
Setting range [mm]
spacing/proportional, and a character
"000.000"–"055.000"
string width for justify.
"000.000"–"030.000"
"000.000"–"085.000"
"000.000"–"090.000"
The rotation center is the origin of the
character strings.
With LP-400/V compatible command
mode, the fonts from No. 10 cannot be
set and readout.
• If you do not make characters bold,
• If you make characters bold, set the
The correction ratio is calculated using
the value set at the laser settings as
100%.
Remarks
character strings is the origin for the
character object.
command mode, the vertical
alignment is always set to "first
baseline".
set 0.000.
bold line width to 1/2 or less of the
character height or width, whichever
is smaller.
75