Table of Contents
Advertisement
1-2 "Marking settings" screen
In this screen, you can create and edit marking data such as character, graphic and bar code objects and save them in a
file. If you are logged in as "Restricted user", only the parameters allowed to edit are available.
You can do the following:
• Create new marking data.
• Edit a marking or backup file that is saved on a local or network drive (offline mode).
• Edit a marking file that is saved on the laser marking system (online mode).
• Execute test marking (online mode).
„ User interface overview
1
2
3
4
Item
1
Ribbon - setting tools
2
File number and file
name
3
Marking image editor
4
Status bar
5
Ribbon - control tools
6
Marking settings
• Object settings
• Function settings
• File settings
• Laser settings
• On-the-fly marking
8
Description
You can use the tools to execute file handling, create or edit marking data.
The number and name of the selecting file are displayed in the tab.
The image of marking data such as characters and graphics is displayed in this area.
Refer to "Marking image editor" (P.10).
In online mode, it displays any of the following information:
• Current operation mode (remote mode or RUN mode)
• Laser pumping status (on or off)
• Error number if any error is occurred
You can use the tools to control the laser marking system in online mode.
Set the marking data in the following tabs:
:
Specify settings of the marking object such as character, graphic and bar code objects.
:
Configure the function such as counter, expiry time and lot.
:
Specify the settings such as position, trigger parameters which are applied to all
objects in a marking file.
:
Specify laser parameters such as laser power and scan speed.
:
Specify on-the-fly marking settings if you want to mark a workpiece in motion. (LP-RC,
LP-RF, LP-RV)
ME-NAVIS2-QR-1
5
6
Advertisement
Table of Contents
