Communication Settings - Panasonic LP-GS Series Serial Communication Command Manual

1-4-2 Communication settings

Item
Communication protocol
Standards
Applicable cable
Applicable HUB (or rooter)
IP address
Subnet mask
Default gateway
PC configuration software port
Command communication port
* Do not use "127" in the first octet.
• The communication control of the laser marker through the Ethernet should be performed in a secure network settings.
• Even the IP Address and Subnet Mask values are within the configurable range, they may not be available depending
on the combination.
• For the details of the communication settings, refer to "1-1-3 Settings before external control" (P.14).
⿎ Ethernet communication settings for communication command control
Item
Start code
Response data command
Sub command
Character code
Encoding for 2-byte
characters
Check sum
End code
Reception timer
Ethernet communication settings
TCP/IP
IEEE802.3 (10BASE-T) / IEEE802.3u (100BASE-TX)
Category 5 or higher
10BASE-T / 100BASE-TX compatible
1.0.0.0 to 223.255.255.255 * (Initial value: 192.168.1.5)
128.0.0.0 to 255.255.255.254 (Initial value: 255.255.255.0)
1.0.0.0 to 223.255.255.255 * (Initial value: 0.0.0.0 (Unspecified))
1025 to 65534, except 9090 (Initial value: 9093)
1025 to 65534, except 9090 (Initial value: 9094)
Ethernet communication settings (LP-400/V compatible mode)
• Setting request data, Readout request data, Response data for readout: STX
• Positive response code: ACK
• Negative response code: NAK
Included only in response data for readout
• Setting request data: S
• Readout request data: R
• Response data for readout: A
ASCII code
Shift-JIS code
OFF
CR
Timeout monitoring ON (10 sec.)
ME-LP-GS-SR-COMP-3
23