Point Radiation Correction: Prf - Panasonic LP-GS Series Serial Communication Command Manual

3-9-2 Point radiation correction: PRF

Specifies the offset value of the position and laser power to the all points set in the selected object no.
⿎ Setting request data / response data for readout
Start
PRF
code
Sub command is "S" for the setting request data and "A" for the response data for readout.
⿎ Readout request data
Start
PRF
code
⿎ Data description
Name
(> Name in LP-400/V)
Object No.
(> Point radiation No.)
System reserved value
X-offset
Y-offset
Laser power correction
Pulse cycle correction *
Total data length
* Only for LP-RF series and LP-RV series.
⿎ Data example
Condition: Object No. = 1, System reserved value = 0, X-offset = 0, Y-offset = -5.6, Laser power correction = 130,
Pulse cycle correction = 100
• Setting
Transmission data
• Readout
Transmission data
Response data
112
[Object. No.] [System reserved value]
[X-offset] [Y-offset] [Laser power correction]
Sub
[Pulse cycle correction]
command
LP-GS / LP-RC: 22-byte
LP-RF / LP-RV: 25-byte
[Object No.]
R
2-byte
Data length
[byte]
2 "00"–"15": Object No. 1400 to 1415
1 "0"
8
"-999.999"–"+999.999" [mm]
8
3 "000"–"999" [%]
(3) "001"–"999" [%]
22 Fixed length.
or • LP-GS / LP-RC series: 22-byte
25 • LP-RF / LP-RV series: 25-byte
[STX] PRF
[STX] PRF
[STX] PRF
(Check
End code
sum)
Data content
S 010+000.000-005.600130100
R 01 [CR]
A 010+000.000-005.600130100
ME-LP-GS-SR-COMP-3
(Check
End code
sum)
Remarks
Moves the all points set in the selected
object no. from currently set position.
• The correction ratio is calculated
using the value of laser power for
each point as 100%.
• When laser power correction ratio
is set to "000", all points set in the
specified point radiation no. are not
scanned at lasing.
The correction ratio is calculated using
the value set at the laser settings as
100%.
[CR]
[CR]