Module Filling Of 2D Codes: Brp - Panasonic LP-GS Series Serial Communication Command Manual

3-7-5 Module filling of 2D codes: BRP

Sets the laser settings and filling details with a font by each element of the 2D code (QR codes and Data matrix codes).
• If the object type set in the specified object number is not the bar code/2D code, the laser marker returns the negative
response.
• The settings by this command are applied only to QR codes, micro QR codes, Data matrix codes and GS1 Data matrix
codes. To specify the module fill spacing of the other codes, use WDC command (line width / filling line spacing).
• With LP-400/V compatible command mode, you cannot set and readout the settings for QR code for Chinese characters
(GB/T 18284) and iQR code by this command.
• With LP-400/V compatible command mode, you cannot set and readout the settings for QR code with the mode setting
"Auto" by this command.
• With LP-400/V compatible command mode, the other filling patterns than the font cannot be set and readout.
⿎ Setting request data / response data for readout
Start
BRP
code command
Sub command is "S" for the setting request data and "A" for the response data for readout.
⿎ Readout request data
Start
BRP
code
⿎ Data description
Name Data length
(> Name in LP-400/V)
Object No.
(> Bar code No.)
Code element
Character code
(JIS Code)
[Object No.] [Code element] [Character code]
[Laser power correction] [Scan speed correction]
Sub
[Pulse cycle correction]
LP-GS/LP-RC: 12-byte
LP-RF/LP-RV: 15-byte
[Object No.] [Code element]
R
2-byte
Data contents
[byte]
1 "0"–"7": Object No. 1100 to 1107
QR code:
"0": Quiet zone outline
"1": Dark module
"2": Light module
"3": Alignment
"4": Finder
1
Data Matrix code:
"0": Quiet zone outline
"1": Dark module
"2": Light module
"3": Border
"2230"–"2239"
"8121"–"8152"
"0000": Do not mark, or use the
4
same setting with the dark/light
module for the alignment, finder or
border.
ME-LP-GS-SR-COMP-3
(Check
sum)
(Check
End code
sum)
Remarks
When the code type is micro QR code, you
do not need to set "alignment".
• Specifies the character code of the font
used as a filling pattern in JIS code.
• To the quiet zone outline, dark module
or light module, inputting the character
code "0000" encodes the 2D code with
blank for the specified part.
• To the alignment, finder or border,
inputting the character code "0000"
allows to use the same filling pattern of
the dark/light module.
End code
103