Qos Classification - Tenda V1200 User Manual

Key It specifies the key number of the QoS queue rule.
Interface It specifies the wireless interface the QoS queue rule applies.
Qid It specifies the value the QoS queue rule.
It specifies the priority level of the QoS queue rule. A lower value indicates a higher
Prec/Alg/Wght
priority.
Enable It specifies the status of the QoS queue rule.
4.10.2

QoS classification

To add a QoS classification rule:
Step 1 Choose Advanced Setup > Quality of Service > QoS Classification to enter the
configuration page, and click Add.
Step 2 Traffic Class Name: Enter a name for the rule.
Step 3 Rule Order: Keep the default value Last.
Step 4 Rule Status: Select Enable to enable the rule.
Step 5 Set the required parameters of specify classification criteria.
1. Ingress Interface: Select an interface from which the data traffic comes.
2. Ether Type: Select an Ether type of the Ethernet packets.
3. Source/Destination MAC Address: Enter the source/destination MAC addresses.
4. Source/Destination MAC Mask: Leave them blank.
When the Ether Type is set to IP (0x800) or IPv6 (0x86DD), the following parameters need
to be specified.
Source/Destination IP Address[/Mask]: If you do not specify the source/destination MAC
−
address, you need to specify the source/destination IP Address for the classification.
Differentiated Service Code Point (DSCP) Check: Select a DSCP mark for the data
−
streaming.
Protocol: Select a protocol.
−
UDP/TCP Source/Destination Port: Enter the port information for the data streaming.
−
Step 6 Set the required parameters of specify the classification results.
130