Qos; Bandwidth Control; Traffic Statistics - Tenda FH305 User Manual

3 QoS

3.1 Bandwidth Control

Use this section to manage bandwidth allocation to devices on your LAN. If there are multiple PCs behind your router competing for limited
bandwidth resource, then you can use this feature to specify a reasonable amount of bandwidth for each such PC, so that no one will be over
stuffed or starved to death.
Enable Bandwidth Control: Check or uncheck the box to Enable or disable the bandwidth control feature.

IP Address: Specify the same IP address (say, 100, 100) or two different IP addresses (say, 100, 110) in both boxes to specify a single

IP address or an IP range to which the current bandwidth control rule will apply.
Upload/Download: Select to control bandwidth over data upload or download.

Bandwidth Range: Specify an upload/download bandwidth range limit on specified PC(s). The unit is KByte/s. 1M=128KByte/s. Note

that maximum upload/download bandwidth should not exceed your router's WAN bandwidth limit. (Consult your ISP if you are not clear.).
Enable: Check to enable current rule. (When disabled, corresponding entry will not take effect though existing in fact.)

Add to List: Click to add current rule to the rule list.

OK: Click to activate your settings.

For example:
If you are sharing a 4M broadband connection with a neighbor, who always exhausts the bandwidth resource downloading data, this feature will
help. Simply specify half of the 4M bandwidth for your neighbor's PC (say, 192.168.0.100) and you will no longer need to struggle for
bandwidth and your neighbor will only get up to 2M bandwidth. To do so, follow instructions below:
1. Check Enable.
2. Input "192.168.0.100" in both IP address boxes.
3. Select Download.
4. Enter "256" in both bandwidth range fields.
5. Check Enable.
6. Click Add To List
7. Click OK.

Traffic Statistics

Traffic Statistics allows you to see at a glance how much traffic each device in your network is using.
Enable Traffic Statistics: Check/uncheck the box to enable/disable the Traffic Statistics feature. To see at a glance how much traffic each

device in your network is using, enable this option. However usually, disabling it may boost your network performance. This option is
disabled by default. However, once enabled the page refreshes every five minutes.
OK: Click to activate corresponding settings.

IP Address: Displays IP addresses of PCs connected to the device.

.
28
User Guide