Tenda V1200 User Manual page 83

Parameter
PPP IP extension
Use Static IPv4 Address
Enable PPP Debug Mode
Bridge PPPoE Frames Between
WAN and Local Ports
Enable IGMP Multicast Proxy
7. Enter the PPPoE user name and password, set other parameters as required based on the
parameter description above, and click Next.
8. Leave the configuration unchanged on Routing - Default Gateway page, and click Next.
Default gateway interface list can contain multiple WAN interfaces serving as system
default gateways. The first WAN interface has the highest priority.
9. If your ISP provides you DNS IP addresses, select Use the following Static DNS IP address,
and enter the DNS IP addresses information. If not, select Select DNS Server Interface
from available WAN interfaces, and click Next
Description
If this option is selected:
The NAT and firewall functions are disabled.

Only a computer in LAN can obtain the IP address which is the same as

that of the WAN port to access the internet. Other compurters cannot
obatin IP addresses to access the internet.
It is used to set up the IP address assigned by the ISP after the PPPoE dial-up
succeeds. Do not set up it if you are not a professional.
If it is enabled, you can check the PPPoE dial-up information on the System
Log page. It is used to diagnose dial-up malfunctions.
If it is enabled, computers in LAN can share the WAN connection for internet
access, use multiple active PPPoE accounts to access the internet (if any).
If it is enabled, the modem router can forward the multicast data to the users
in LAN. If you requires multicast applications, such as VOD or AOD, you can
enable this option.
73