Weather Protection; How To Attach The Weather Protection To The Device - Honeywell RM640 Handbook

INSTALLATION
3
• Use the display extractor to remove the display module from the housing. Put the display
extractor in the slots on the module for these clips.
• Carefully remove the display module from housing and then remove the display extractor from
the display module.
• Turn the display module until it points to the user.
• Put the display module back on the electronics block. If the clips make a click, then the display
module is correctly attached to the electronics block.
• Make sure that the housing cover has a gasket. Attach the cover to the housing and tighten it
by hand.
i End of the procedure.
INFORMATION!
The cover wrench and display extractor are supplied with the device. If it is necessary to send an
order for the cover wrench or the display extractor, refer to Accessories: general items on page
176
.

3.11 Weather protection

3.11.1 How to attach the weather protection to the device

Figure 3-20: Equipment needed to assemble the weather protection
1 Weather protection cover (with an R-clip to hold the cover on the clamp)
2 Device
3 Weather protection clamp (2 parts)
4 2 locking nuts
5 10 mm socket wrench (not supplied)
The overall dimensions of the weather protection are on page 141.
44 www.honeywellprocess.com
RM640
34-VF-25-131 iss.1 GLO Feb 2019 US