OPERATION
6
Figure 6-9: A plot of points for a volume or mass table
1 Silo with reference points
2 Silo model with plotted points
How to delete a volume or mass table
• Enter Program mode.
• Push 2 × [ ], [> > > > ], 2 × [ ] and 2 × [> > > > ] to go to C3.1.1 Erase Table?.
• To delete strapping table data that the device uses at this time (Erase Table?), push [ ] and
[ ] to set this menu item to "Yes".
• Push [^ ^ ^ ^ ] again and again to go back to the "Save Configuration?" screen.
• The device will ask you to save or cancel your settings. Push [ ] or [ ] to make a selection
from Yes
Yes, No
Yes
Yes
to "Yes" or No", push [^ ^ ^ ^ ] to accept (Yes) or reject (No) the new settings.
i
If you push [^ ^ ^ ^ ] when the screen is set to "Yes", the device will delete the data for the
strapping table and go back to Normal mode.
110
No or Back
No
No
Back. Back
Back
Back
Back makes the display go back to Program mode. If this screen is set
Back
Back
www.honeywellprocess.com
RM640
34-VF-25-131 iss.1 GLO Feb 2019 US