Program Mode; General Notes - Honeywell RM640 Handbook

RM640

6.3 Program mode

6.3.1 General notes

Change the settings of your device in Program Mode
You can:
• Use the A Quick Setup
change settings, do standard setup and empty spectrum recording procedures.
• Use the B Test
• Use the C Full Setup
or mass measurement, change current output values, change HART® settings, change how
the measurement data is shown in Normal mode, read device identification data, change
critical parameters for difficult process conditions, change the password, change
measurement units or reset the device to factory default settings.
CAUTION!
If you did not supply all installation data to the supplier before the delivery, the standard setup
procedure in the Quick Setup menu is mandatory.
INFORMATION!
It is not possible to enter the D Service
personnel only.
34-VF-25-131 iss.1 GLO Feb 2019 US
A Quick Setup menu to change the display language, change the tag name, log in to A Quick Setup A Quick Setup
B Test menu to run diagnostic tests, read measurement and spectrum data.
B Test B Test
C Full Setup menu to change settings. You can set up a conversion table for volume C Full Setup C Full Setup
D Service menu. This menu is for factory calibration and approved D Service D Service
Program Mode. Data about the menus is given on page 80.
Program Mode Program Mode
www.honeywellprocess.com
OPERATION
6
67