Operation; User Modes; Normal Mode - Honeywell RM640 Handbook

RM640

6.1 User modes

Normal mode

Normal mode
Normal mode Normal mode
Program mode Program mode Program mode Program mode
6.2 Normal mode
This mode shows measurement data. Use the display keypad to change the type of
measurement data shown on the screen and to read the device status messages.
There are 5 options to show the measurement data on the display screen. Refer to the
illustration that follows:
Measurement data options
Figure 6-1: Measurement data options in Normal mode
1 One value
2 One value and % bar graph of the scale for the measurement value
3 Two values
4 Two values and % bar graph of the scale for the top measurement value
5 Three values
34-VF-25-131 iss.1 GLO Feb 2019 US
This mode shows measurement data and status messages. For more data
about measurements, refer to
about status messages, refer to
page 112.
Use this mode to read and change parameters, commission the device,
create tables for volume or mass measurement, and change critical values
to measure in difficult process conditions. To change settings in Program
mode, you must use the device with the correct access level (user, operator
or expert). For more data about menu items, refer to
on page 80.
All users can read the settings in Program mode, but only users with
"Operator" and "Expert" access levels can change settings. For more data
about access levels, refer to
levels)
on page 68.
www.honeywellprocess.com

OPERATION

Normal mode on page 63. For more data
Status messages and diagnostic data
Function description
Protection of the device settings (access
6
on
63