Table of Contents
Advertisement
OPERATION
6
B – Test menu
Menu
Function
No.
B1 Simulation
B1.1 Set Value
B1.1 Set Value
B1.1 Set Value
B1.1 Set Value
B1.1.2
Level
B1.1.3
Distance
B1.1.4
Reflection
82
Function description
This sets the device to a given test level
value. Make sure that menu item
C4.1.1 Current Out. 1 Var. is set to
"Level" before the device simulates a
level value. This procedure sends an
output signal that agrees with the test
reading. Output will change to the
selected value, independent of the
measurement data.
When you push [^ ^ ^ ^ ] to confirm the
value, the display shows the question
"Start Simulation?" Push [ ] or [ ] to
set the display to "Yes". Push [^ ^ ^ ^ ] again
to start the test. The device goes to
back to Normal mode after 1 hour.
Minimum access level to do the
Minimum access level to do the
Minimum access level to do the
Minimum access level to do the
procedure: Expert
procedure:
procedure:
procedure:
This sets the device to a given test
distance value. Make sure that menu
item C4.1.1 Current Out. 1 Var. is set to
"Distance" before the device simulates
a distance value. This procedure sends
an output signal that agrees with the
test reading. Output will change to the
selected value, independent of the
measurement data.
When you push [^ ^ ^ ^ ] to confirm the
value, the display shows the question
"Start Simulation?" Push [ ] or [ ] to
set the display to "Yes". Push [^ ^ ^ ^ ] again
to start the test. The device goes to
back to Normal mode after 1 hour.
Minimum access level to do the
Minimum access level to do the
Minimum access level to do the
Minimum access level to do the
procedure:
procedure:
procedure: Expert
procedure:
This sets the device to a given test
reflection value. Make sure that menu
item C4.1.1 Current Out. 1 Var. is set to
"Reflection" before the device
simulates a level value. This procedure
sends an output signal that agrees with
the test reading. Output will change to
the selected value, independent of the
measurement data.
When you push [^ ^ ^ ^ ] to confirm the
value, the display shows the question
"Start Simulation?" Push [ ] or [ ] to
set the display to "Yes". Push [^ ^ ^ ^ ] again
to start the test. The device goes to
back to Normal mode after 1 hour.
Minimum access level to do the
Minimum access level to do the
Minimum access level to do the
Minimum access level to do the
procedure: Expert
procedure:
procedure:
procedure:
www.honeywellprocess.com
Selection list
min-max:
-4900.0...+5100.0 m /
+03
+03
-192.91
...+200.79
in /
-16076...+16732 ft
min-max:
-4900.0...+5100.0 m /
+03
+03
-192.91
...+200.79
in /
-16076...+16732 ft
min-max:
0...100%
34-VF-25-131 iss.1 GLO Feb 2019 US
RM640
Default
1
1
1
Advertisement
Table of Contents
