Honeywell RM640 Handbook page 83

RM640
Menu Function
No.
B1.1.5 Level Lin.
B1.1.6 Volume
B1.1.7 Mass
34-VF-25-131 iss.1 GLO Feb 2019 US
Function description
This sets the device to a given test level
value (linearized). This menu item is
only available if you set up a
linearization table in menu item C3.1
Edit Table. Make sure that menu item Edit Table Edit Table Edit Table
C4.1.1 Current Out. 1 Var. is set to "Lin.
Level" before the device simulates a
level value. This procedure sends an
output signal that agrees with the test
reading. Output will change to the
selected value, independent of the
measurement data.
When you push [^ ^ ^ ^ ] to confirm the
value, the display shows the question
"Start Simulation?" Push [ ] or [ ] to
set the display to "Yes". Push [^ ^ ^ ^ ] again
to start the test. The device goes to
back to Normal mode after 1 hour.
Minimum access level to do the Minimum access level to do the
Minimum access level to do the Minimum access level to do the
procedure: Expert procedure: procedure: procedure:
This sets the device to a given test
volume value. This menu item is only
available if you set up a conversion
(volume) table in menu item C3.1 Edit
Table. Make sure that menu item Table
Table Table
C4.1.1 Current Out. 1 Var. is set to
"Volume" before the device simulates a
volume value. This procedure sends an
output signal that agrees with the test
reading. Output will change to the
selected value, independent of the
measurement data.
When you push [^ ^ ^ ^ ] to confirm the
value, the display shows the question
"Start Simulation?" Push [ ] or [ ] to
set the display to "Yes". Push [^ ^ ^ ^ ] again
to start the test. The device goes to
back to Normal mode after 1 hour.
Minimum access level to do the Minimum access level to do the
Minimum access level to do the Minimum access level to do the
procedure: procedure: procedure: Expert procedure:
This sets the device to a given test
mass value. This menu item is only
available if you set up a conversion
(mass) table in menu item C3.1 Edit
Table. Make sure that menu item Table
Table Table
C4.1.1 Current Out. 1 Var. is set to
"Mass" before the device simulates a
mass value. This procedure sends an
output signal that agrees with the test
reading. Output will change to the
selected value, independent of the
measurement data.
When you push [^ ^ ^ ^ ] to confirm the
value, the display shows the question
"Start Simulation?" Push [ ] or [ ] to
set the display to "Yes". Push [^ ^ ^ ^ ] again
to start the test. The device goes to
back to Normal mode after 1 hour.
Minimum access level to do the Minimum access level to do the Minimum access level to do the Minimum access level to do the
procedure: Expert procedure: procedure: procedure:
www.honeywellprocess.com
Selection list
min-max:
-5000.0...+5000.0 m /
+03
-196.85
C3.1 C3.1 C3.1
-16404...+16404 ft
min-max:
+06
0...1.00
C3.1 Edit C3.1 Edit C3.1 Edit
min-max:
+09
0...10.000
C3.1 Edit
C3.1 Edit C3.1 Edit
OPERATION
Default
1
+03
...+196.85 in /
1
m³
1
kg
6
83