GE AF-650 GP Programming Manual page 105

Parameter Descriptions
EN-37 COS Inhibit Timer
Range:
[0–65.535
ms]
3 3
EN-38 COS Filters
Range:
[[0-9] Filter 0–9
(0000-FFFFhex)]
EN-40 Status Parameter
Range:
0 [0 - 0]
*
NOTE
This parameter is for Modbus TCP only
EN-41 Slave Message Count
Range:
0
*
NOTE
This parameter is for Modbus TCP only
EN-42 Slave Exception Message Count
Range:
0
*
NOTE
This parameter is for Modbus TCP only
EN-80 FTP Server
Option:
[0] Disabled
*
[1] Enabled
EN-81 HTTP Server
Option:
[0] Disabled
*
[1] Enabled
EN-82 SMTP Service
Option:
[0] Disabled
*
[1] Enabled
104
Function:
Read only Change-Of-State inhibit timer. If the
option is configured for COS operation, this
inhibit timer can be configured in the Forward
Open telegram to prevent that continuously
changing PCD data generates extensive network
traffic. The inhibit time is in milliseconds,
0=disabled.
Function:
Change-Of-State PCD filters. Sets up a filter
mask for each word of process data when
operating in COS-mode. Single bits in the
PCD's can be filtered in/out.
Function:
Function:
[0 - 0]
Function:
[0 - 0]
Function:
Disables the built-in FTP server.
Enables the built-in FTP server.
Function:
Enables the built-in HTTP (web) server.
Function:
Enables the SMTP (e-mail) service on the option.
AF-650 GP Programming Guide
EN-89 Transent Socket Channel Port
Range:
0 [0–9999] Configures the TCP port-number for the transent
*
EN-90 Cable Diagnostic
Option:
[0] Disabled
*
[1] Enabled
NOTE
The cable diagnostics function is only issued on ports
where there is no link (see EN-10 Link Status, Link Status)
EN-91 Auto Cross-Over
Option:
[0] Disable
[1] Enable
*
NOTE
Disabling of the auto cross-over function requires crossed
Ethernet cables for daisy-chaining the options.
EN-92 IGMP Snooping
Option:
[0] Disable Disables the IGMP snooping function.
[1] Enable Enables the IGMP snooping function.
*
EN-93 Cable Error Length
Range:
0 [0 -
*
65535]
DET-618C
Function:
socket channel. This enables Drive-messages to be
sent transently on Ethernet via TCP. Default value
is 4000, 0 means disabled.
Function:
Enables/disables advanced Cable diagnosis
function. If enabled, the distance to cable errors
can be read out in EN-93 Cable Error Length. The
parameter resumes to the default setting of
Disable after the diagnostics have finished.
Function:
Disables the auto cross-over function.
Enables the auto cross-over function.
Function:
This prevents flooding of the Ethernet protocol
stack by only forwarding multicast packets to ports
that are a member of the multicast group.
Function:
If Cable Diagnostics is enabled in EN-90 Cable
Diagnostic, the built-in switch is possible via Time
Domain Reflectometry (TDR). This measurement
technique detects common cabling problems
such as open circuits, short circuits, and
impedance mismatches or breaks in transmission
cables. The distance from the option to the error
is displayed in meters with an accuracy of ±2 m.
The value 0 means that no errors detected.