Emerson Tescom ER5000 Series User Manual page 165

ER5000 — The ERTune™ Program: Basic Features
The Commands in the Profile Builder
The unit of measurement for the setpoint value parameter
IMPORTANT! IMPORTANT!
in these commands matches the unit of measurement for feedback set
during Step 7 of the Setup Process
change the range of feedback values tracked by the ERTune™
Step
Initiates a step setpoint change to the value entered in the
to Step to
entry field.
Ramp
Initiates a ramp setpoint change to the value entered in the
to Ramp to
entry field. The duration, in seconds, of the ramp-up or
Time to Ramp (sec)
ramp-down is set in the
or when you followed the steps To
program.
Setpoint
Setpoint
entry field.
Dwell
Maintains the current setpoint for the amount of time, in seconds,
Time to Dwell (sec)
entered in the
Loop
Allows the Profile to loop multiple times through a sequence of
command segments, beginning with the segment entered in the
Loop to Segment
entry field.
NOTE NOTE
The command sequence will run the number of times entered in
Number of Loops
the entry field. A value of 0 in the
CAUTION CAUTION
field will cause the loop to run perpetually.
WARNING WARNING
entry field.
Number of Loops
entry
165