Emerson Tescom ER5000 Series User Manual page 127

ER5000 — The ERTune™ Program: Basic Features
Navigating the ERTune™ User Interface
The Menu Bar
The menu bar displays three menu items on the left.
NOTE NOTE
If the ER5000 does not detect a feedback signal, a warning will
display on the right side of the menu bar.
CAUTION CAUTION
WARNING WARNING
The File Menu
The File menu has three commands.
Save Configuration
This command saves the current tuning configuration to a text
file. The file can be saved anywhere on your computer or network
and uses the .tun file extension.
Change Configuration
This command loads a saved configuration (.tun) file into the
ERTune™ program and downloads the tuning configuration to the
ER5000.
Exit
This command exits the program.
The Node Menu
The Node menu has two commands.
Node Select
This command opens the Select Node window, which allows you
to select between ER5000s when you have multiple controllers in
the same network.
To switch between controllers based on Node Address
Node -> Node Select. The Select Node window opens.
1. Select
2. Enter the Node Address of the controller you wish to access.
NOTE NOTE
Individual controllers connected via USB should be at the
default Node Address of 250, unless this was changed during setup.
CAUTION CAUTION
If you have multiple controllers in an RS485 network and are not
sure of the Node Address for each controller, refer to the
WARNING WARNING
Node command on the next page.
3. Click Select. The ERTune™ program begins communicating
with the controller at that Node Address and displays the
controller's configuration information.
Search
127